Free shipping on orders over 75.
Repairing rollers anderson patio sliding door.
Tandem roller assembly for andersen gliding patio doors.
Start with a good cleaning.
Scrub caked dirt and grime out of the track with a stiff brush and soapy water.
To clean and lubricate the hardware of a sliding closet door use a stiff brush a toothbrush or a hand vacuum to clean dust from the tracks.
Inspect the door s rollers to see if they re gummed up broken or have come loose.
Remove the plug and use a screwdriver to tighten and loosen the roller height making very small adjustments and testing each time.
How to repair sliding door rollers to work on patio door rollers lay the door down on a flat surface ideally a pair of sawhorses or a table.
Also called sliding glass doors these doors are designed to glide horizontally with one operating panel and one stationary panel.
Buy parts direct from the andersen online parts store.
If the rollers are damaged install replacement rollers available at home centers.
Insert the replacement sliding door rollers into the cavity along the bottom of the door.
Sliding glass door repair will get the job done.
They fit into tighter spaces than our hinged doors because their panels don t interfere with your room or patio.
Andersen gliding patio door tandem roller 1997061 gliding patio door tandem roller part.
This video shows the basics of removing rollers in an andersen sliding door and replacing them with aftermarket tandem rollers.
Use an aerosol lubricant to lubricate all the door rollers.
If the door still doesn t slide smoothly the rollers under the door either need adjusting or are shot.
Most sliding patio doors have one or two small holes at the top and bottom of the door for adjusting the roller height.
Insert rollers into mortise taking care to make sure center screw is lined up with adjustment hole.
Replace the bottom frame.
If the problem is just a loose roller tighten or replace the loose screws that hold it in place.
Located at bottom of moving door.
Use the wooden block and rubber mallet to gently tap the frame back onto the.
Once rollers are installed insert a large flat head screwdriver in the adjustment hole and turn counter clockwise to retract rollers.