You may need the philips screwdriver again to free the door from the track.
Removing sliding glass door frame.
You should now be able to freely lift the sliding glass door out of the frame and out of the track.
Remove the door by pulling it out of the top track of the door frame.
Do the same on both the left and right ends of the sliding door.
At the bottom of this panel locate the position of the adjustment roller.
Just type lsailor1 in the youtube search bar.
Removing sliding glass closet doors.
Once the door is completely loose from the frame set it aside somewhere safe such as against the side of the house or lying flat on a work bench.
Determine the size of the screwdriver you ll need reach back into the gap with your screwdriver and adjust that screw counter clockwise as far as it will go.
Sometimes these screws are covered in plugs that are usually easy to remove.
If you are completely removing the sliding glass door to install a new door you can now remove the door frame by using the pry bar.
Use the phillips screwdriver to loosen the adjustment screws so you can pull up the rollers.
Position the pry bar at the base of the trim pieces and pry upward to expose the trim s nail shafts.
Begin by grasping the door closest to you.
How to remove a glass patio sliding door frame step 1.
Once you remove all the screws lift the door up and make sure that it is completely removed from the bottom track of the door frame.
Initial steps the sliding door also has a moving panel and a stationary panel along with a door frame.
You may like my other videos.
The door should slide right out of the top track once you ve freed it from the bottom track.
Sliding panel open the sliding panel.
Remove this cap because as you ll notice it is covering a gap inside of which is a screw.
The door guide is usually located in the center of the doors.
You will be doing a lot of prying to free the frame from the door jamb.
Use your cordless drill and philips drill bit to remove the door guide from the floor.