Remove Door Panel 07 Ford F150

Remove the 2 front door lower bolts.

Remove door panel 07 ford f150.

In just 3 minutes watch a front passenger door panel removal from a 2007 11th gen ford f 150 supercrew extended cab. You must lift up on the panel to clear the holes. Pry off the door switch assembly and disconnect the harness on the back. When the panel is free pop the door handle out by rapping it with your hand from behind as it has a little snap clip holding it in.

The door panel is held on by fingers that slot into holes in the door. Unplug the two connectors for the master window switch the door lock switch and mirror switch. Remove the bolts holding the speaker in place pull it out and disconnect the harness on the back. Free shipping on many items browse your favorite brands affordable prices.

Remove the window control switch by pry up on the trim around the switch and it will release. Remove the door release cable by squeezing the tabs on the blue plastic clip passing it through the hole and disengaging the cable from the handle. Lift upward to remove the front door trim panel. Remove the front door speaker trim panel.

You will need to disconnect the courtesy lamp wire before moving the panel more than a few inches. Grabbing the entire door panel slide it up and then pull it off but still support it. Remove the front door trim panel. Remove the door handle by unclipping it from the door panel on the rear side of the panel then slide it through the panel.

Step 1 remove the door panel remove the two bolts on the bottom of the door panel then pry off the trim piece in the front middle section over the door speaker. Make sure nothing else is attaching the door panel to the truck then set it to the side. Guide the door handle through the opening in the trim panel. Remove the 2 speaker standoffs.

Lift the door panel up to disengage the tabs that hold it in place. With panel screws all removed carefully lift the door panel up and away from the door but only a few inches. Do not pull directly outward on the front door trim panel as damage may occur. Un clip any wiring harnesses from the switch panel.

Stage 3 shows you how. Disconnect the electrical connector.