Remove Arm Rest Door Grab Handle 2010 Toyota Corolla

Then remove the single screw behind the door opener handle with the phillips head screwdriver by turning it counter clockwise and set it aside in a safe place.

Remove arm rest door grab handle 2010 toyota corolla.

Pull up the armrest panel and remove the exposed phillips screws. Simple and detailed instructions to make this job simple enough for anyone to do. Pull the little phillips clip out on the side of the door panel. Remove and set aside the door handle.

Move to the door pull handle well in the arm rest and pry open the round screw cover. Then you remove the triangle plate for the outside mirror. Dorman has all the components needed for a complete repair. Then with a flat head screw driver you lift up the arm rest piece to expose the two screws holding the arm rest to the door.

2 screws trim panel. Pry up the switch panel. It has seating inside for two in the front and two or more people in the back with a window for each passenger. Door arm rests by dorman.

Disconnect the wiring harness. Quickly and easily installed it eliminates the clunking noise that may result when this part fails while restoring original ride control. Use a putty knife to unpin the door panel from the door. First you remove the inside door handle again unclip the plastic clip make sure when you put the door back together that this clip gets back on.

The corolla is a sedan designed by toyota that is slightly smaller than the camry.